WSDU-2X4SER
The WSDU-2X4SER is a multicoupler that distributes signals from a common input to four outputs, each in two independent sections. Section A is optimized for shortwave signals with the highest dynamic and linearity requirements, while section B offers extremely high bandwidth for spectrum monitoring. The device is available in AC or DC power versions, as well as with a remote control interface.
radio monitoring 2 inputs with 4 outputs each section A: 200 kHz … 30 MHz section B: 20 MHz ... 8000 MHz
Lossless 1 to 4 Signal Distributions
The RF input the signal is amplified by using innovative broadband low-noise amplifiers with a wide dynamic range -weak signals are linearly amplified even if they occur next to signals with very strong levels. As a result, the distributed input signal is made available at the four outputs of each section without any loss in level.
The hardware structures of the distributions offer best phase and amplitude balance performance.
All RF inputs and outputs have N female connectors.
Variants for AC and DC Supply
WSDU-2X4SER is available in two variants for supply the unit with AC or DC power. Both variants cover a wide voltage supply range.
Device Monitoring
WSDU-2X4SER device is equipped with a built-in device monitoring capability which offers optical signalization of the device health as standard. For remote monitoring a variant with LAN and USB remote interfaces is available. Via the remote interfaces information about operating points of the internal wideband amplifier stages, the module temperature and the device identification can be queried in form of ASCII strings. The variant with remote monitoring supports SNMP (simple network management protocol) which enables monitoring without any effort, even in complex environments. The WSDU-2X4SER is able to identify failures and to inform the supervising system automatically.
Latest modification: 08.09.2025